VARILITE NEW ICON BACK 

- Designed with user, therapist and technician in mind

 COMFORT

- Rollover Cover

The Icon™ Back System features an innovative rollover cushion to protect the user from contact with the edge of the shell during extension or weight shifting activities.

- Air and Dual-stiffness foam

The Icon™ Back System incorporates a VARILITE air foam floatation cushion. Sculpted foam fits the shell contour without bunching. Multi-stiffness foam is thickest along the vertebral column. Soft foam protects the sensitive areas of the spine while firmer foam supports the sides of the trunk. A two-way air valve allows air in and out of the cushion for a custom fit and adjustable comfort.

- Breathable Fabric

Spacer knit fabric on the outside of the cover increases air-flow between the user and the back support. 

EASE OF INSTALLATION

The Icon™ Back System installs on a wheelchair quickly and easily. Only two parts need to be attached to the wheelchair – all other hardware components are pre-installed. All adjustment screws are the same. Only a single tool is needed.

Icon™ hardware is symmetrical so there are no right-handed or left-handed components. SymmetricaL hardware provides a wide range of seat depth adjustment, without any need for special, extra length parts. Posterior seat depth can be increased or anterior depth decreased by reversing the hardware. Symmetrical hardware simplifies ordering and management of spare parts.

EASE OF USE

The Icon Back System is designed for users who are on the go. Operating the system is as easy as opening the latches and sliding the back support out of the hardware. Latches stay in an open position until the back is removed, making it simple to remove the support with one hand or for those with limited dexterity. The hardware guides the back support back into position with minimal effort and locks it securely into place. Red safety markings alert the user that a latch is open and not in the locked position.

 EASE OF ADJUSTMENT

Adjusting the angle, width, height and depth of the Icon™ Back System hardware is simple and easy. All adjustment screws are accessible from the rear of the back support or from the outside of the upright brackets. Only one tool is needed. Adjustments can be made while the user is in the wheelchair.

Once adjusted, the Icon™ hardware stays in place. The upright brackets clamp securely and will not slip. The innovative Adjuster Plate mechanism for recline adjustment is positive locking to prevent the back support from moving during daily activities or at other times when heavy loads are placed on it.

VERSATILITY AND CHOICE

Icon Back provides four different types of back.

- Icon Low Back combines the Icon hardware features with a sleek, low profile look. It is an ideal lightweight solution for users needing lower trunk support and the full adjustment normally only found in a larger style of back.

- Icon Mid Back provides support and positioning to improve trunk control and decrease fatigue. it supports the user to just below the scapulae so the back does not interfere with arm movement during propelling or other activities.

- Icon Tall Back is well suited for those needing additional support, or using a tilt and recline system.

- Icon Deep Back is ideal for users needing maximum support.

SAFETY

ACCESSORIES

Both PAL Swing-Away thoracic supports and Fixed Lateral Support are available to help position the wheelchair users.

Other addistional supports such as PSIS Block or Supplemental Lateral Supports can also be attached to the shell of the Icon Back System for correct positioning.